Where a flush-mounted installation must also deliver task-quality light, this recessed kit pairs the standard recessed aluminium profile with a frosted diffuser for 85% light transmission — noticeably brighter than the opaline version while still producing a clean, even light face. The profile installs flush in drywall with spring-clip retention. Full component details are listed below. Included: 1× Recessed aluminium profile (8 ft) 1× Frosted diffuser 4× Mounting springs 1× Open end cap 1× Closed end cap Compatible LED Tape Lights: 3528 - 8 mm (5/16 in.) 5050 - 12 mm (1/2 in.) COB - 8 mm (5/16 in.)

For a clean, flush-mounted LED tape installation in drywall or millwork, this recessed kit delivers a complete assembly with nothing extra to source. The anodized aluminium profile sits within the substrate with only the opaline diffuser face visible in the finished surface. At 55% light transmission, the opaline diffuser produces soft, ambient light with no hot spots — ideal for residential ceilings, coves, and feature walls. Full component details are listed below. Included: 1× Recessed aluminium profile (8 ft) 1× Opaline diffuser 4× Mounting springs 1× Open end cap 1× Closed end cap Compatible LED Tape Lights: 3528 - 8 mm (5/16 in.) 5050 - 12 mm (1/2 in.) COB - 8 mm (5/16 in.)

For lighting that disappears into the wall or ceiling, this recessed aluminium profile installs flush within drywall using spring clips, leaving only the diffuser face visible when finished. The 8ft channel accommodates standard indoor LED tape and is compatible with Arani's full recessed-profile accessory range including diffusers, end caps, and mounting springs. Profile body only — pair with a frosted or opaline diffuser for a complete installation. Compatible LED Tape Lights: 3528 - 8 mm (5/16 in.) 5050 - 12 mm (1/2 in.) COB - 8 mm (5/16 in.)

At the cable-entry end of a recessed aluminium profile, this open end cap provides a clean, flush-mounted exit point for the LED tape wiring without disrupting the flush surface appearance. It snaps onto the profile end without adhesive or tools, protecting the channel edge while allowing clean wire routing to the driver. Pair with the recessed closed end cap at the sealed end.

For recessed aluminium profile installations, this closed end cap seals the channel end flush with the surrounding surface, protecting the cavity while maintaining the clean, integrated appearance of the flush-mount installation. It snaps in without adhesive and sits flush to the substrate for a seamless finish. Use at the non-wiring end; pair with the recessed open end cap at the cable-entry side.

Designed for recessed aluminium profile installations where the channel must sit flush within drywall, these spring clips secure the profile from behind the substrate surface with no visible hardware on the finished face. Space them every 2 feet along the run, minimum two per profile length, for a stable installation that will not sag or shift once the tape and diffuser are in place.